SB312 12″ Offset Square Coupler
PopUp Extended Coupler gives you an additional sixteen inches clearance between the truck cab and the trailer nose, and between the truck tailgate and the trailer bulkhead. This gives you more trailer swing and more room for hook-up. To make your towing experience better yet, this extended coupler is fitted with a PopUp GN8 self-latching coupler.
These units are fabricated using extra heavy wall tubing for maximum strength. They are rated at 24,000 pounds gross trailer weight.
Short Bed Extended Couplers come with all necessary hardware and coupler release cabling.
Installation takes about half an hour.
- If your trailer doesn’t have a thru pin, drill a hole and install a 1/2″ or larger bolt.
- Verify that the gussets on the trailer will clear the side rails of your truck.
If the 12″ is to much offset, take a look at our SB1 9″ offset, or if it’s not enough the SB116 16″ offset might better fit your needs.
Fits trailers with 4″ ID square tube
Our Part measures 4″ outside to outside and is manufactured with USA steel. Make sure it fits your trailer downtube. Some manufacturers use Import tubes, and many are Not sized consistently or are out of round or square. PopUp assumes No responsibility for returns when incorrect measurements are taken. Please see return policy.
Quick Facts
- Fits trailers with 4″ ID square tube
- Precision coupler casting extends life of ball.
- 1″ holes thru both sides
- 12 Inch offset between truck and trailer.
- Self-latching GN8 2-5/16″ coupler.
- 24,000 lbs. GTW, 5,000 lbs. Vertical Tongue Wt.
- Includes coupler release cable and hardware.
Video
This coupler latches when the trailer is lowered onto the ball. It also has a molded hitching guide to make coupling easier. To uncouple, you simply pull a release cable located near the trailer jack handle. The GN8 coupler has a rating of 28,000 pounds. Video is of the SB116 but installed the same as the SB112.
Made in America
What our customers are saying